Examining the Major Types of Sealants and Coatings for Concrete Garages

Industry News, Sealants,

There are four major types of sealants and coatings that are used to protect concrete parking garages: surface sealers, penetrating sealers, thin bond overlays, and traffic-bearing overlays. Costs differ significantly as do the levels of protection that they provide, so it is essential that the type of protection selected is well suited for that particular application. 

Surface Sealers 
Surface sealers are a liquid applied treatment that forms a thin coating on the concrete surface with little or no penetration. Most are epoxy or polyurethane based. They are easy to apply, require very little down time, and are the least expensive option for maintenance managers, typically costing less than a dollar per square foot.  

While they do provide protection against moisture and will produce a uniform appearance, they have a low resistance to abrasion. As a result, they are better suited for use in pedestrian areas of facilities or in areas with low volumes of vehicular traffic. Even in these areas, annual re-application of the sealer is required to continue the protection.  

Surface sealers are considered to be a good first level of defense for the concrete of garages that are either new or are in very good condition. However, they are ineffective in applications where the concrete surface is not in good condition or where some structural damage has already taken place. 

Penetrating Sealers 
Penetrating sealers also are a liquid applied treatment, but unlike surface sealers, they penetrate into the concrete where they form a barrier that repels water and water born chlorides. They too are easy to apply, requiring little down time, and produce a uniform appearance of the concrete surface. They are more expensive than surface sealers, typically costing between $1 and $2 dollars per square foot. 

Like surface sealers, penetrating sealers are a good first level of defense for garages that are new or are in good condition. They have an average service life of three to five years, depending on the level of traffic. To be effective, the concrete surface must be intact and without structural defects. 

Thin Bond Overlays 
The next higher level of protection can be achieved through the use of epoxy or methacrylate sealer. With a typical thickness of one-eighth to three-eight inches, these overlays form a hard surface that lays on top of the concrete and prevents moisture from penetrating the concrete surface. These overlays offer protection in both new and older facilities, including those with some damage to the concrete surface, including cracking. While they will not bridge cracks, they will fill pores in the concrete.  

Most applications run in the range of $5 to $7 per square foot, and offer a service life of five to 10 years depending on their exposure to vehicular traffic. Depending on the particulars of the application, the overlays can be made to be slip resistant through the use of additives. A fairly wide range of colors is available.


Source: Facilities.net